LabVIEW FPGA: June 14-15, 2012

The LabVIEW FPGA course prepares you to design, debug, and implement efficient, optimized applications using the LabVIEW FPGA Module and reconfigurable I/O (RIO) hardware. You learn how to compile and deploy your VIs to different types of NI targets, such as NI R Series multifunction RIO, CompactRIO, Single-Board RIO, and NI RIO instruments. You develop applications where you learn to acquire digital and analog I/O, control loop timing, synchronize operations, implement signal processing, and pass data between your host VI and your FPGA target.
The LabVIEW FPGA course focuses on programming practices for applications with I/O rates less than 5 MHz or using R Series, CompactRIO, or Single-Board RIO targets.
National Instruments offers another LabVIEW FPGA Module training course, High-Throughput LabVIEW FPGA, focused on programming LabVIEW FPGA for I/O rates higher than 5 MHz. If you are using NI FlexRIO or other FPGA hardware targets with extremely high-performance I/O and real-time and low-latency FPGA-based processing such as NI FlexRIO, consider instead the High-Throughput LabVIEW FPGA class.
Note: The Embedded Control and Monitoring Using LabVIEW course is a 5-day classroom training replacement for the LabVIEW Real-Time 1, LabVIEW Real-Time 2, LabVIEW FPGA classroom training.
Prerequisites:
LabVIEW Core 1 & 2 courses or equivalent experience
Course Objectives:
Design, prototype, and deploy an embedded control & monitoring application
Acquire and generate analog and digital signals, control timing, and implement signal processing on RT and FPGA
Implement additional functionality on the RT target for logging, network communication, system health monitoring, and reliability using the LabVIEW Real-Time Module
Course Information:
June 14-15, 2012
8:15 AM - 4:30 PM
Peak Technical Training Center
9939 Via Pasar
San Diego, CA 92126